Operating voltage?7.4-8.4V
Operating speed:
7.4V-0.135sec/60′
8.4V-0.13sec/60′
Dynamic torque:
7.4V-23kg-cm
8.4V-25kg-cm
Horn gear spline?25T
Size?40x20x42mm
Weight?74g

Limit angle:180±10°(500-2500?sec)
Rotating direction:180°(1000-2000?sec)
Operating travel :220
Neutral position :1520?sec
Maximum:?180°(500-2500?sec)
Pules width range :500-2500?sec
Dead band width:2?sec
Connector wire length:350 mm

Operating voltage 7.4-8.4V
Operating speed:
7.4V-0.12sec/60′
8.4V-0.11sec/60′
Dynamic torque:
7.4V-20kg-cm
8.4V-22kg-cm
Horn gear spline?25T
Size 40x20x38mm
Weight?66g

Limit angle:180±10°(500-2500sec)
Rotating direction:180°(1000-2000sec)
Operating travel :220
Neutral position :1520sec
Maximum:180°(500-2500sec)
Pules width range :500-2500sec
Dead band width:2sec
Connector wire length:350 mm

Features:
Operating Voltage: 6V
6V: Speed: 0.25 sec/60 degrees, Torque: 8.5kg-cm
Servo Spline: 25T

Dimensions:
Main case: 40.0×42.0x20.0mm (excluding mounting tabs, servo spline, & cable outlet)
Mounting tab hole centres: 48.5×10.0mm
58g (excluding servo horn)

NOTE: This servo is water-resistant only, meaning it is resistant to splashes and brief contact with water. It is not waterproof and therefore not suitable for submerged used. Before driving in wet conditions, make sure that all electronics fitted to the vehicle are safe to use (marked as water-resistant or waterproof), or that they are fully enclosed and protected from water and moisture (such as in a sealed receiver/battery case). Fans mounted on speed controllers are not water resistant – we recommend to disconnect the fan from the ESC before driving in wet conditions and allow it to dry fully before reconnecting the fan power. Lubricate exposed metal drivetrain parts such as bearings, outdrives and diff shafts before driving in wet conditions. Motors are not intended for submerged use and may be damaged if used when under water. After driving in wet conditions, make sure to rinse off dirt and any corrosive liquids like saltwater with plain water and re-lubricate metal drivetrain parts.

Compatible with:

• MAVERICK PHANTOM XT

Features:
Operating Voltage: 6V
6V: Speed: 0.22 sec/60 degrees, Torque: 5.5kg-cm
Servo Spline: 25T

Dimensions:
Main case: 40.0×37.5×20.0mm (excluding mounting tabs, servo spline, & cable outlet)
Mounting tab hole centres: 48.5×10.0mm

Weight: 45g (excluding servo horn)

NOTE: This servo is water-resistant only, meaning it is resistant to splashes and brief contact with water. It is not waterproof and therefore not suitable for submerged used. Before driving in wet conditions, make sure that all electronics fitted to the vehicle are safe to use (marked as water-resistant or waterproof), or that they are fully enclosed and protected from water and moisture (such as in a sealed receiver/battery case). Fans mounted on speed controllers are not water resistant – we recommend to disconnect the fan from the ESC before driving in wet conditions and allow it to dry fully before reconnecting the fan power. Lubricate exposed metal drivetrain parts such as bearings, outdrives and diff shafts before driving in wet conditions. Motors are not intended for submerged use and may be damaged if used when under water. After driving in wet conditions, make sure to rinse off dirt and any corrosive liquids like saltwater with plain water and re-lubricate metal drivetrain parts.

INFORMAÇÃO DO PRODUTO:

ESPECIFICAÇÕES DO PRODUTO

Tipo: Digital
Rolamento: Dual
Tipo de motor: DC
Tipo de engrenagem: Metal
Material da engrenagem: cobre e alumínio
sistema de controle: controle de largura de pulso
frequência de trabalho: 1520μs / 330hz
tensão de operação: DC4.8-7.4v
faixa de temperatura operacional: -10 a + 60 graus
velocidade operacional (4,8 V): 0,16 s / 60 graus sem carga
velocidade operacional (6,0 V): 0,12 seg / 60 graus sem carga
velocidade operacional (7,4v): 0,10 seg / 60 graus sem carga
torque de estol (4,8v): 1,9kg.cm (26,4 oz / in)
torque de estol (6,0v): 2,5kg.cm (34,7 oz / in)
torque de estol (7,4v): 2,8kg.cm (38,9 oz / in)
acionamento do potenciômetro: acionamento direto
dimensões: 22,5x12,5x24,0 mm / 0,89x0,49x0,94 pol.
peso: 16,0g (0,56 oz)
comprimento do fio do conector: jr 300 mm

Control electronics: digital
Dimensions: 23,2 x 12,0 x 30,0 mm
Gearing: metal
Weight: 13 g
Housing: plastic
Speed @ 4,8 V: 0,12 s/60 °
Speed @ 6,0 V: 0,10 s/60 °
Torque @ 4,8 V: 3,00 kg/cm
Torque @ 6,0 V: 3,50 kg/cm
Motor: standard
Cable: PVC 220 mm
Connection: compatible with JR

Control electronics: analogue
Dimensions: 23,0 x 12,2 x 29,0 mm
Gearing: plastic
Weight: 9 g
Housing: plastic
Speed @ 4,8 V: 0,12 s/60 °
Speed @ 6,0 V: 0,11 s/60 °
Torque @ 4,8 V: 1,50 kg/cm
Torque @ 6,0 V: 1,70 kg/cm
Motor: standard
Cable: PVC 250 mm
Connection: compatible with JR